Comments
1. The implemented battery status feature checks the backup battery resistance once in 24 hours and sends an SMS report to all preset users on battery replacement in case more than 2,5 mΩ resistance is detected.
2. At the moment both partition arming using 1 keyboard password is not available. However it will be available in future firmware release.
Best regards,
UAB ELDES
Q2)Why ESIM 264 is not able to be armed with one code(both partitions 0 and 1)and the EKB3 is not able to see both partitions?
As mentioned previously, at least one of the LEDs of EKB3 (ARMED / READY / SYSTEM) stay always illuminated, therefore the location of EKB3 will still be visible in dark areas. This keypad was designed in a different way comparing to EKB2, therefore a permanent key back-light is not available in EKB3.
Best regards,
UAB ELDES
Thanks for your answers,but I still have an EKB3 keypad with keys totally extinguished after few min. of illumination.How can I hope to locate my only one keypad in total darkness without a minimum illumination ?.For exemple,a DSC LED keypad has three levels of permanent illum.
Kind regards
The EKB3 keeps the back-light of the keys active for approx. 1 minute after the last pressing of any keypad key. In any case at least one of EKB3 LEDs stay illuminated continuously, therefore you will be able to locate your keypad even in darkness and illuminate the keys after pressing any of them. However EKB2 keypad has an always-active self-controlled back-light which lowers down automatically after a few minutes of inactivity.
Best regards,
UAB ELDES